The Life of a Gangster That Started In a Gun Shop

"Ye, how is it? Do you have any ideas?"

Ye Qing, who didn't know whether to be happy that the Saudi army was too wasteful, or sad that her first work was going to be dusty, just left the military camp with O'Hafa, and heard O'Hafa's question from the back.

"There are some, but the specifics still need to be tested."

Ye Qing was talking while walking.

"I'm not lying to you, O'Hafa. Although I've never been a soldier, but from this barracks, the core problem of your Saudi army is not weapons at all. Look at those fat guys..."

"I know, but we can't do anything..."

O'Hafa nodded and agreed with Ye Qing's statement.

"So I will try to simplify the structure as much as possible. If the caliber is concerned, I will initially consider choosing a 7.62mm bullet. This kind of bullet will be much more powerful. Basically, one shot will destroy an enemy's combat effectiveness."

The strength of Wu Qiang has never been absolute, but the key is the person who controls the weapon.

This is like a LOL game, what Akali, Knife Girl, VN, the heroes are very strong, and the upper limit is extremely high. But if you play it for a novice, it is better to let him take a big health care "hula la" to play the trick.

The same goes for the Saudis, according to Ye Qing.

The weapons they use are similar, and it's not as good as clockwork Ak, swarming up. Anyway, they are holding other weapons, and their play is almost the same...

"For the main structure, please refer to Ak. But I will add the modular system, and then correct some of Ak's faults. The current thinking is probably this. Do you have any other suggestions?"

"I don't know about this, as long as you don't really do an Ak cross."

O'Hafa shrugged, a little helpless.

Ye Qing's words were a bit unpleasant, but that was the truth. O'Hafa also had to admit that the gang would be much better with a 7.62*39mm rifle than a 5.56...

After all, caliber is justice...

Ignoring the topic of guns, the two had some other gossip on the plane. When Ye Qing returned to the hotel, the computer prepared by O'Hafa was also delivered.

Looking at the AMD3990X on this computer, this processor known as the thread tearer, plus the configuration of 4 RTX Titans, Ye Qing was speechless.

What I said was to have better performance... but there's no need to go overboard, right? !

In addition to computers, monitors, keyboards and mice are full of Saudi style. Not necessarily the best, but it must be expensive! Perhaps in O'Hafa's eyes, better performance and higher price are the same thing...

Although it seems that there is no problem...

But what are you doing with the table and chairs in the entire space capsule? !

Lying down and doing design... This special lady is really a big **** the sedan chair. This is the first time...

Taking advantage of the installation efforts of the workers and masters, Ye Qing instructed the housekeeper to prepare a few cigarettes and some drinks such as Red Bull, and then went downstairs to have a nice dinner.

When I went back to the room, everything that needed to be prepared was ready. Ye Qing took the cigarette apart, and then took the ashtray to the armrest of the capsule seat.

Turn on the computer, install software such as CAD, and start your own work.

The blueprint is the blueprint, but in fact there are many problems to be dealt with.

The AK's strengths are as obvious as its weaknesses.

Reliable performance, meat and vegetables are not taboo, but the accuracy is poor, bullets can fly around 300 meters away...

What's more troublesome is that the reliable performance of the AK stems from its simple mechanical structure. As far as the firing mechanism is concerned, the firing mechanism of the AK is even simpler than some pistols.

The trigger is directly connected to the sear, and when the trigger is pulled, it means that the sear is released. The hammer hits the needle directly under the action of the trigger spring...

In addition to this, the extra parts are just behind the hammer, probably just above and a little behind the trigger connection, with a single-shot sear and a single-shot converter.

The single burst converter with the most complicated name is, to put it bluntly, a piece of iron...

When in the burst gear, this piece of iron will block the single-shot stinger, making it unable to rebound to hook the hammer. In this way, the hammer is not locked, and under the action of the spring, the striker will be repeatedly struck again and again to achieve the purpose of bursting.

It is such a simple firing structure that gives the Ak a powerful reliability. But also because the structure is too simple, the inside of the gun body is actually relatively empty.

Connected to the problem of the center of gravity, the high-pressure gas after the bullet is fired is transmitted into the gas pipe to push the piston with the rear seat of the bolt. As a result, the rear structure is empty and the force of the rear seat is too great. Often the bolt will hit the bolt frame directly...

And this is also one of the key reasons for the low accuracy of AK. And it's easy to break the sights...

Thinking about these questions, Ye Qing found that there seemed to be no solution. Unless an exhaust hole is added to the air pipe, the impact force of the high pressure gas on the piston is reduced. But doing this, if you are not careful, it is easy to cause the bolt to not be able to recoil in place, which is more troublesome.

And adding such a thing, the power is not enough, it will also have a great impact on the rate of fire of the weapon.

After thinking about it, Ye Qing found that being lazy is still a must... Instead of thinking about how to change the AK, it is better to redesign it.

We say designing a weapon, to be precise, a gun.

It is necessary to mention a few key positions.

First, the firing mechanism, as the name suggests. As long as it is related to the control of the launch of the weapon, it belongs to the firing mechanism. Generally speaking, it is composed of trigger, trigger spring, sear, hammer and insurance.

At this point, Ye Qing didn't want to give up the AK's original simple firing mechanism design. The more complicated the firing mechanism is, the more troubles will follow~www.wuxiaspot.com~ For example, we often hear about the jamming problem, most of which are mechanical failures caused by the complicated firing mechanism. After all, if there is a problem with the locking mechanism of the bullet, it is often the consequence of exploding the chamber...

The second is the locking mechanism. The locking mechanism should be called the bolt locking mechanism to be precise. Its function lies in two points, one is to stabilize the state of the bullet in the chamber to be fired. Let the bullet lie firmly in the barrel of the gun.

The second, and most crucial, is to control the recoil rhythm of the bolt. The powerful high-pressure gas when the bullet is fired, and the force transmitted to the piston through the gas tube, is enough to push the bolt back seat, so why isn't the bolt bolt back seated at the moment the bullet is fired?

This is what the locking mechanism does. When the bullet is loaded, lock the bolt so that the bolt cannot be recoiled. It can prevent the high-pressure gas from directly pushing the empty shell to move backward, and it can also prevent the gas from dumping backwards prematurely, so as to ensure the power of the bullet.

The bolt rotary locking mechanism used by the AK rifle is also the locking mechanism of mainstream weapons. This locking method is very difficult to process, and the stiffness of the locking is also very good.

With a rifle designed for the purpose of mass deployment, Ye Qing naturally couldn't give up this simple and excellent locking mechanism that has been actually used by the military of various countries and has been tested for a long time.

In this way, it is said to give up the design concept of Ak, and as a result, it goes back...

​​

Please remember the first domain name of this book: . Mobile version update fastest URL: